9

I noticed that the pinout for cheap Baofeng connectors has +V available. I'm interested in powering some electronics directly from this connector.

When unloaded, this seems to have about 3.3V on it, but when I try to power my load (an ESP32), the voltage drops to 0.8V.

How much current can this pin actually provide without significant voltage drop? Or, what does the voltage/current curve look like?

Evan Krall
  • 321
  • 2
  • 8
  • 1
    Have you measured the current draw of your ESP32 to rule out a fault? – Phil Frost - W8II May 29 '19 at 17:42
  • 3
    The voltage is probably meant to bias an electret microphone, so I wouldn't be surprised to hear that that terminal can't source much current. – rclocher3 May 29 '19 at 19:48
  • 3.3v is a common level for logic signals in electronics. [This page](http://www.miklor.com/COM/UV_Technical.php) linked in the other question seems to indicate V+ can be used for PTT 2 - is that not the case? – JPhi1618 May 30 '19 at 18:16

2 Answers2

10
  • With no load, I measure 3.17V
  • With 100kΩ load, 2.91V
  • With 10kΩ load, 1.59V
  • With 1kΩ load, 0.29V

The math works out to a 10kΩ series resistance between +V and ground.

As such the maximum power that can be drawn is at 1.59V/10kΩ load, or 0.25mW max power. Short circuit current would be about 0.3mA.

rclocher3
  • 9,112
  • 3
  • 20
  • 49
Evan Krall
  • 321
  • 2
  • 8
8

I would first measure the current draw of your ESP32 to rule out a fault there.

The +V pin on the Baofeng microphone connection is probably intended to bias an electret microphone. These are essentially a capacitor, with sound pressure changing the spacing between the plates and thus the voltage. They contain a FET buffer since the capacitor could not drive a cable directly. The buffer requires power, but very little: the bias current is probably far less than 1 mA.

Thus it's quite likely the +V pin is unable to supply even a small current. Adding a series resistance on such a pin would have no impact to the intended use of biasing a microphone, but is a cheap and effective way to protect the radio from all kinds of faults that could happen on such a connector.

Phil Frost - W8II
  • 51,321
  • 5
  • 84
  • 209
  • 1
    Almost certainly an electret mic. The only other possibility would be for the PTT; pressing it might feed 3.3 volts back to the main board. – Mike Waters May 30 '19 at 15:39