4

In particular I'd like to know what schemes PCI Express, PCI and ISA use at the physical layer.

amiregelz
  • 8,099
  • 12
  • 48
  • 58
wnrph
  • 3,633
  • 1
  • 26
  • 39

1 Answers1

1

They're all different. You can easily look up each one. PCI Express uses low-voltage differential signalling. PCI uses both 5 volt and 3.3 volt signalling levels. ISA uses simple TTL signalling.

David Schwartz
  • 61,528
  • 7
  • 100
  • 149
  • so 1 and 0 zero are resp. coded as 5 V and 0 V signal levels in pci? – wnrph Dec 05 '11 at 19:40
  • PCI supports both 5V and 3.3V signalling. Most likely, the actual signalling rules are something like: For 5V signalling, 0 is less than .7 volts, 1 is more than 3 volts. For 3.3V signalling, 0 is less than .3 volts, 1 is more than 2 volts. – David Schwartz Dec 05 '11 at 19:43
  • wow, the ISA spec fits on a couple of pages. I wonder what the PCIe spec is in kilo grams. – wnrph Dec 05 '11 at 19:56
  • Regarding differential signaling: Is there a direct mapping of the levels of the regenerated difference signal onto 0 and 1 as with the unipolar scheme in PCI and ISA? – wnrph Dec 05 '11 at 20:18
  • The typical setup is that at least a .247 volt difference is required to indicate a legal value. The maximum a driver is permitted to output is a .454V difference. The average voltage of both differential outputs remains between 1.125V and 1.375V. Which line is at a higher voltage than the other determines if it's a 1 or a 0. (Of these buses, PCI-Express is the only one that is serial and the only one that uses differential signalling. You may need to double-check these values against different versions of PCI-Express, but it's about right.) – David Schwartz Dec 05 '11 at 20:36