Questions tagged [propagation]

Questions about RF propagation including measurements, beacons, modes (ionospheric, tropospheric, ground wave), etc.

RF propagation is the behavior of radio waves when they are transmitted. As a form of electromagnetic radiation radio waves are affected by the phenomena of reflection, refraction, diffraction, absorption, polarization and scattering.

RF propagation is affected by the daily changes of water vapor in the troposphere, ionization in the upper atmosphere due to the Sun, the frequency of the emission, the path over ground of the transmission. If the path is over-the-horizon path aided by refraction in the ionosphere, it will be influenced by factors that include sporadic-E, spread-F, solar flares, geomagnetic storms, ionospheric layer tilts, and solar proton events.

Propagation Modes

Surface modes (groundwave) — LF (between 30 and 3,000 kHz) have the property of following the curvature of the earth via groundwave propagation. In this mode the radio wave propagates by interacting with the semi-conductive surface of the earth. The wave "clings" to the surface and thus follows the curvature of the earth. Vertical polarization is used to alleviate short circuiting the electric field through the conductivity of the ground. Since the ground is not a perfect electrical conductor, ground waves are attenuated rapidly as they follow the earth’s surface. Attenuation is proportional to the frequency making this mode mainly useful for LF and VLF frequencies.

Direct modes (line-of-sight) — Line-of-sight is the direct propagation of radio waves between antennas that are visible to each other. This is probably the most common of the radio propagation modes at VHF and higher frequencies.

Ionospheric modes (skywave) — Skywave propagation, also referred to as skip, is any of the modes that rely on refraction of radio waves in the ionosphere, which is made up of ionized layers in the upper atmosphere. F2-layer is the most important ionospheric layer for long-distance, multiple-hop HF propagation, though F1, E, and D-layers can also play significant roles.

The D-layer, when present during sunlight periods, causes significant amount of signal loss, as does the E-layer whose maximum usable frequency can rise to 4 MHz and above and thus block higher frequency signals from reaching the F2-layer. The layers, or more appropriately "regions", are directly affected by the sun on a daily cycle, a seasonal cycle and the 11-year sunspot cycle and determine the utility of these modes.

  • Meteor scattering
  • Auroral backscatter
  • Sporadic-E propagation

Tropospheric modes

  • Tropospheric scattering
  • Tropospheric ducting
  • Tropospheric delay
  • Rain scattering
  • Lightning scattering

Other effects

  • Diffraction
  • Absorption
146 questions
30
votes
2 answers

Which HF bands are best during the day and which are better at night?

I am rather new to HF operation and have recently purchased my first HF rig. I have read about bands being "open" and "closed" based on various conditions including time of day. As I have been listening, I have been bouncing around all the bands…
ghendricks
  • 637
  • 1
  • 6
  • 11
18
votes
2 answers

How do I make a RF propagation map for a repeater?

Let's say I have a repeater. Knowing all of the information about antenna height and gain in each direction, as well as power, how can I create a map similar to this map I saw of a repeater in Illinois? Free options are always better!
Skyler 440
  • 7,550
  • 7
  • 48
  • 88
17
votes
2 answers

Is free space path loss dependent on frequency?

Free space path loss is calculated as: $$ \left( 4 \pi df \over c \right)^2 $$ The presence of $f$ in this equation means that losses increase with increasing frequency, so there's an inherent advantage in lower frequencies, right?
Phil Frost - W8II
  • 51,321
  • 5
  • 84
  • 209
16
votes
7 answers

What is the cause of this unusually long period of terrible HF band conditions?

I've been a ham for over 40 years, but never has there been such a prolonged period of such poor propagation. This has been especially the case over the past six months or so, and they continue to deteriorate. What could possibly be the cause? This…
Mike Waters
  • 7,843
  • 4
  • 16
  • 50
16
votes
4 answers

What bands and modes will give me voice at 3,000 miles?

I pursued Amateur Radio primarily for local emergency communications and as part of my electronics education. My only radio right now is an inexpensive 2m/70cm HT which is good for local weather spotting and emergency operations. I'm interested in…
Adam Davis
  • 12,095
  • 2
  • 45
  • 106
14
votes
3 answers

Why do concurrent FM signals not mix together?

Generally when I hear two conflicting signals they do not mix together, but rather one dominates then the other. This phenomenon can be observed on FM broadcast station when driving out of range from one station into the range of another. During the…
Dan
  • 1,754
  • 3
  • 16
  • 36
12
votes
2 answers

How much RF energy do trees and branches absorb?

For the 20m - 10m and 6m bands, will having my dipoles below the tops of trees (I live in redwood forests) drastically affect the RF power out or radiation patterns of my dipoles if I can still get them at least 1/4 wavelength above the ground? Or…
gdc
  • 298
  • 2
  • 8
11
votes
4 answers

How does VHF/UHF propagate beyond the expected (radio) horizon?

I am not asking about the fairly well-known effect of the earth "appearing less curved to radio waves" that are otherwise still essentially line-of-sight, but a deeper arcanum: In the ARRL Antenna Book, 17th edition (1994) there is a discussion of…
natevw - AF7TB
  • 7,219
  • 2
  • 23
  • 58
11
votes
6 answers

Does iron ore in the ground affect my signal?

Mineral content in the ground varies from one place to another. I've visited places where the ground & waters were an orange-red shade from the high iron content; not good for trees either. This post on eHam.net, seems to indicate there may be…
VU2NHW
  • 2,814
  • 2
  • 19
  • 42
11
votes
2 answers

What would propagation look like on Mars?

If we could get a few HF stations on Mars, what would the propagation look like? Thought shamelessly copied from this blog.
PearsonArtPhoto
  • 6,158
  • 2
  • 31
  • 61
11
votes
6 answers

Practical limits to maintaining coherence in an HF channel

Lately I've been thinking about weak signal communication on HF. Very weak, like weaker than even WSPR could achieve. It would be nice if one could simply take any existing modulation and slow it down to achieve an arbitrarily high Eb/N0 and thus,…
Phil Frost - W8II
  • 51,321
  • 5
  • 84
  • 209
10
votes
3 answers

Using MIMO in Amateur Radio?

MIMO, Multiple Input, Multiple Output, is used widely in commercial data transmission. 802.11n and LTE devices use it to increase throughput, link reliability, and channel usage without increasing transmission power or using more bandwidth. While…
Adam Davis
  • 12,095
  • 2
  • 45
  • 106
10
votes
3 answers

Does modulation affect propagation?

Does the modulation scheme, whether OOK, SSB, AM, FM, a digital mode, etc, affect the propagation of a signal?
Adam Davis
  • 12,095
  • 2
  • 45
  • 106
10
votes
1 answer

What's the difference between "maximum usable" and "critical" frequencies?

In discussing HF ionospheric propagation, you hear about both "critical" and "maximum usable" frequencies. For example: Above the critical frequency, the ionosphere is unable to refract the signal back to Earth and it escapes to space. The critical…
natevw - AF7TB
  • 7,219
  • 2
  • 23
  • 58
10
votes
4 answers

How do I find out what bands are open?

Say the deck is stacked. I'm out in the country with an all-band QRP home-brew rig, and an active antenna. Or say ship-wrecked and marooned on that desert island. The battery only has enough juice for say 1-min Tx, and 30-min Rx. The Sun is at the…
VU2NHW
  • 2,814
  • 2
  • 19
  • 42
1
2 3
9 10